Jump to 0 top | 1 navigation | 2 content | 3 extra information (sidebar) | 4 footer | 5 toolbar


Content

Find the perfect person to paint the interior or exterior of...

Paint Types in House Painting

Choosing your paint is probably the most important thing you will do on your project. This is because most paints are designed for a specific purpose. Primer paints are designed to adhere to raw surfaces and then to stick to a protective coat over the top of it. In general, there are four types of raw surfaces that you might want to paint over, wood, masonry, drywall, and bare metal. You should be able to find a primer that will work on your bare surface. Do not be tempted to simply skip the primer coat as finish paints will sometimes not stick well to the surface, especially metals.

The big question for many painters is whether they should use oil or water based paints. Glossy oils tend to be more impermeable to water and will bubble up if the surface beneath is damp. Latex and other water based paints will make wallpaper peel. Industry experts have argued for a long time over which formula is better in general. For exterior applications, water-based paints have the upper hand. Besides allowing the house to breathe, they tend not to crack as readily. In addition, they have the great advantage of water clean up. In addition, if you are worried about the ultimate environmental impact, water-based paints tend to be friendlier to the eco-system. Oil paints usually have a stronger and more overpowering odor. You should always ventilate well when painting, but it will seem even more vital with oil-based paints.

Even so, oil is often the choice to make, especially when painting over a surface that was previously painted with an oil base. If you simply must use a water-based paint over an oil-based paint, you should sand down the finish then prime it so that the paints will adhere to each other.

Although the price is not always the best indicator of quality, it does serve as a good general guideline. Also, the warrantee on paint will indicate how long it is likely to last. Remember that even inexpensive paint is relatively cheap when compared to the amount of time it takes to apply it. Better to have a durable paint that lasts a few extra years than a cheap one that gives out in less than five years.

Pigments in paints also make a difference. Cheaper paints often have cheaper pigments, so they tend not to cover as well, requiring more than one coat. Here again labor is a factor. Two coats of a paint that costs you half as much, is really only doubling your labor. Yellows tend to be the fastest fading color. Titanium dioxide is reported to be the best pigment. If you are buying an expensive paint, be sure to check the can for this ingredient.

Solids are included in paints to thicken the coating. It is calculated as the percentage of the paint that finally adheres to the wall. Solids generally run more than 40 percent of the paint. Higher than 45 is considered good. Do not look for this item on the can, as it is not usually on the label. The solids and pigment are held together with binders. In an acrylic paint, you will want to have all-acrylic binders for exterior paint. For interior paints, this factor is not as important.

Oil and acrylic will both cover most exterior surfaces, but stucco is a special case. Be sure to use an elastomeric paint, which continues to cover small cracks that can develop. Old aluminum siding can be painted. The old paint should be removed and a coat of latex primer and an additional coat or two of exterior paint can then be applied for an acceptable and durable finish.

When you go into the paint store, you will be confronted with flat, satin, and glossy paints. You should use flat for general background surfaces that are not subject to much wear and tear. Satin is better in bathrooms and kitchens where you would like to be able to clean the surface repeatedly over the years. Glossy paints accentuate a surface and bring people’s attention to it. It also tends to be easier to wipe clean. Use glossy paints on cabinets, banisters, some molding and places where little fingers are constantly smudging. Remember, though glossy paints are easier to clean, they tend to show imperfections in wood, drywall, etc.

It probably goes without saying that you should use exterior paints outside and interior paints on the inside. The fact is that exterior paints are designed to be more durable in the elements and interior paints are designed to adhere better to surfaces commonly found indoors. Recent years have brought about advancements in eco-friendly paints with zero or low VOCs. These are worth checking into especially for those who have health concerns or who frequently work with paint.

If you are looking for a hardworking, reliable, and trustworthy person to paint the interior or exterior of your home, the only place to search is on Repairfinders.com. On this site it will only take you a couple of minutes to find a qualified professional in your area who is more than happy to paint your home, quickly, efficiently, and for a reasonable price. For all your repair needs there is only one place to go, and that is Repairfinders.com

  • No ratings
  • No ratings
  • No ratings
  • No ratings
  • No ratings
  • 0 ratings

The basics about Home phone repair revealed!

You pick up the phone to make a call and there is no dial tone on the phone. What do you do? One option is to call the phone company and let them charge you money to tell you that you need to buy a new phone. A better option is to do a some detective work first. If you do end up calling the phone company (from a different phone,) they will ask you questions. With a little investigation, you will know the answer.

 

The phone line is connected to your house at a junction box. Phone geeks call the junction box a “network interface device.” It is usually outside the home near the foundation. A no dial tone problem will fall into two categories. The phone company is responsible for any problem with the junction box or the phone line beyond. The homeowner is responsible for anything wrong from the junction box into the home. That is true unless the homeowner has purchased a service agreement from the phone company. Part of the investigation will be to determine who has to pay to fix the problem, the homeowner or the phone company.

 

Determine if the problem is with one phone or all of the phones in the home. If another phone is working, unplug it and plug it in where the trouble phone was. If the new phone works, you know the problem is in the phone that was plugged in there. To check further, plug the dysfunctional phone into a working phone jack. It will not work there either. It is time to buy a new phone.

 

If no phone in the house has a dial tone, unplug one and take it to the junction box. When you open the junction box, you will see a phone jack. Unplug the wire from the jack and plug in the phone. Does the phone have a dial tone now? If it does, it means that the problem is in the wiring to the house. If it does not, it is time to call the phone company because the problem is theirs.

 

When a cordless phone has no dial tone, there are two additional considerations. Cordless phones do not work without electricity. They do not work in a blackout. Check to see that the power is on, and then proceed as above. Be sure to keep a phone with a cord to use during power outages. Another thing to check is the handset battery. A cordless phone goes dead when the battery does.

If a phone has no dial tone and is plugged into an answering machine, remove the answering machine and plug the phone directly into the phone line to test it. If the phone now has a dial tone, the problem is in the answering machine.

 

When some phones in the house work and others do not, the problem is most likely within the house. Assume that all the non-functioning phone lines connect at some point, probably in the basement or crawl space. By tracing the lines, you can find the junction where the problem is. Many home phone wiring problems can be repaired with modular wires and jacks that need only to be plugged into each other.

 

When the phone does not have a dial tone, do not panic. By following the steps above, you can find the source of the problem quickly and determine if you need to spend some money or if you just need to call the phone company to report the outage. With all the modular wiring and accessories available, most homeowners can fix their own wiring.

 

However folks at home, if you are like me and don’t have time to check these things out, or you don’t want to make matters worse, go to Repairfinders.com and find a qualified telephone inspector that can assist you in fixing any telephone problem that you may have.

  • No ratings
  • No ratings
  • No ratings
  • No ratings
  • No ratings
  • 0 ratings

A couple of things to think about before you start remodelin...

If you are thinking about remodeling your home or office, there are many things to consider. One of the biggest is “should I do it myself?” There is no easy answer to this question, but you can help yourself decide by considering the following questions:

1. Do I have the time?

Remodeling can take a considerable amount of time, even for the experts. Most of the time remodeling is actually more difficult than new construction. One of the reasons for this is that you have to prepare the existing components of your structure to blend in with the new.

2. Do I have the know-how?

Your remodeling project will likely require some specific skills to ensure a successful result. These can include carpentry, painting, drywall finishing, flooring, plumbing, electrical, concrete work, excavation, etc. You’ll want to carefully assess your abilities in the skills you’ll need for your own project.

3. Do I have the tools and equipment needed?

Since so many skills are involved, most property owners do not have the needed tools and equipment. If you can get the tools by purchasing, renting or borrowing them, do you have the skills to use them effectively and safely?

4. Do I have enough help?

Remodeling can be very labor intensive; two hands are often not enough. You can always use someone to help carry materials or equipment, or you might need skilled help in order to complete the job in a reasonable time. If you need help, will you have access to the kind of help you need, when you need it?

5. Am I physically able to do the work?

Remodeling is usually strenuous work, involving climbing ladders, working on scaffolds or heavy lifting. You’ll need to decide if you’re physically able to do that kind of work for the extended period your project may take.

6. Do I have a clear idea of what I am trying to accomplish?

Can you draw the necessary building plans, or will you need to get someone else to do this for you? You may need to hire an architect if your remodel is very complex. An architect can help with traffic flow and other factors that may arise when you change rooms, or move walls and doorways.

7. What is my budget?

You should make a careful estimate of all the costs of your project before any work is started. Calculate the costs of all materials, equipment rental, tools, labor, subcontractors etc. Don’t forget to add a budget for any unknowns or surprises that may be revealed later!

8. What kind of subcontractors am I going to need?

You will probably need some skilled subcontractors to perform specialized work that you can’t do. Do you have the time to deal with those subcontractors personally, and do you have the knowledge needed to negotiate with them? If you are unprepared in this area, it can cost you a lot later on.

You may decide when you’ve finished answering these tough questions that you’ll need some help. If you decide to hire a professional remodeling contractor, you should expect someone with years of experience in construction who can provide all the services listed above, including management of all the necessary subcontractors. Your contractor should take care of everything, and manage your project until it is completed in a timely and efficient manner.

Here’s how to find a good remodeling contractor:

1. Go to Repairfinders.com

On Repairfinders.com you will find only the best qualified professionals in your area. All it takes is a couple minutes of your time to find the right one that is best for you.

2. Check out references

Get previous customers’ opinion of the contractor and the work that was done. Talk to local vendors and suppliers to see if that contractor pays his or her bills.

3. Is the contractor local?

Does he or she have a local office, address or phone number? It’s easier to keep track of a local contractor; avoid hiring from out of town or state unless you thoroughly check them out.

4. Look at the contractor’s work

Make sure you look at previous projects or photos of completed work.

If you’re looking for someone who has roots locally and is likely to be around to stand behind the work done on your project, you might also find out if the contractor you’re considering is involved in the community or in non-profit organizations, or provides support for community projects.

  • No ratings
  • No ratings
  • No ratings
  • No ratings
  • No ratings
  • 0 ratings
Pages: 1 (1 - 3 / 3)